Sign Up to Get
10% Off Your Next Order!
+ 500 FREQUENT BUYER POINTS
Be among the first to receive Weekly Specials & OPGI News.
10% off restoration parts only. 500 Frequent Buyer Points added after promotional order ships. See welcome email for full details.
Sign up for texts from OPGI, and get all our best offers and more!
By subscribing to OPGI text messaging at 80205, you agree to receive recurring autodialed marketing text msgs (e.g. cart reminders) to the mobile number used at opt-in. Consent is not a condition of purchase. Msg frequency may vary. Msg & data rates may apply. Reply HELP for help and STOP to cancel. See Terms and Conditions & Privacy Policy.
ADDED TO YOUR CART!
Hood, Fiberglass, 1981-88 Monte Carlo, 4 Inch Cowl Induction
ADDED TO YOUR WISHLIST!
It's a fact that factory steel hoods are heavy. If your stock hood needs replacing due to rust or an accident, or you want to take some weight off the front end for street performance or racing, these quality fiberglass hoods are the way to go. They have the inserts and substructure so they bolt-on just like your original, but if you select one of the cowl induction-style hoods, you can get more clearance for a high-rise intake manifold and carb/air cleaner combination. Get the stock look with the flat hood, or get the performance of cowl induction with these quality fiberglass hoods.
Regarding Minor Imperfections In Fiberglass Panels: Due to the fragile nature of fiberglass products, we inspect each piece for major damage prior to shipping. It is common for fiberglass components to have small chips and minor imperfections in the gel coat finish. These imperfections are not considered damage as they will be eliminated during the paint preparation process. Fiberglass parts are not shipped in a finished “ready to install” state and will require minimal filling and sanding prior to primer and paint. Test Fit All Panels Prior To Paint and Installation: OPGI recommends test-fitting all sheet metal panels prior to final paint and installation. It is also recommended that the damaged area of the vehicle not be cut out before receiving the new sheet metal. Measure twice, cut once to be safe. Sheet metal panels are not a finished product like door handles and mirrors. Minor modifications including elongating mounting holes, adding shims etc. are normal and may be necessary when installing sheet metal. This is a consideration when reinstalling original GM panels as well as reproductions. It is important to note that hard driving conditions can twist frames and bodies out of original tolerances. Poor bodywork from previous collisions can cause problems with the body structures that the panels are attached to.