ProFit Transmission Swap, Tremec TKX 5-speed, 1964-67 A-Body, .68 OD

Designed to Fit Your Classic 600 lbs/ft of torque capacity

American Powertrain ProFit Tremec TKX manual transmissions and installation kits are designed to fit your classic muscle cars. The TKX has a more streamlined case than the normally used OE design T-56 and T-5 which provides clearance in most transmission tunnels. The rigid 3-piece aluminum housing capable of engines speeds of 8,000 rpm with shifts at 7,500 rpm. TKX 5-Speed Manual Transmission Features and Benefits • Designed, tested and built specifically for the aftermarket. • Designed for multiple applications with three shifter locations. Compact, end-loaded design provides clearance in most transmission tunnels without floor modifications. • Increased case strength with three-piece aluminum housing provides outstanding structural stiffness (includes main case, intermediate plate and rear extension). Gaskets at all flanges simplifies installation and eliminates fluid leaks. • Superior shift-ability through use of multi-cone synchronizers and hybrid synchronizer rings made of sintered bronze and carbon • Noise, vibration and harshness (NVH) minimized with gear layout to best control stress levels. All gears supported by caged needle bearings to reduce end play on the gears. • Equipped with a high-performance short-throw billet aluminum shifter that isolates road noise, while providing clean, crisp shifts. • Robust design with internal three-rail shift system and steel shift forks. • Wide gear width increases gear life and torque capacity. • Built-in reverse light switch and cruise control safety switch.

Tech Specs: Gear ratios 1st 2.87, 2nd 1.89, 3rd 1.28, 4th 1.00, 5th 0.68 26-spline input shaft 31 spline output All gears and shafts made from special grade steel (ASTM 4615) 600ft-lb Constant Load Rated Kit Includes: Tremec TKX17805 AP Revolution Offset Shifter Mechanism - OE 4-speed shift position Driveshaft Slip Yoke - 1330 Solid Yoke, Cryo Hardened Steel Mechanical Speedometer Conversion - Cable adapter compatible with OE cable VSS Wiring Harness - For electronic speedometer or fuel injection ECU Reverse Light Wiring - Weatherseal harness, non-polar Poly Trans mount Pilot Bearing - Roller steel, grease pre-pack (LS and non-LS engine included) Shift Knob - White w/black 5-speed pattern Hardware, Warranty and Instructions