Patch Panel, Door, Lower, 5", 1965-69 Corvair

These stamped steel door patch panels cover the entire width of the door and extend up approximately 5-6" from the bottom of the door. Panels include the side and lower flanges for weld-in installation. Panels are sold for left or right sides as well as in a discounted pair. Correct for 2-door coupe and convertible models.

Regarding Minor Imperfections In Steel Panels: The sheet metal you receive may have scratches, dings, small dents and other minor imperfections, which are considered normal sheet metal characteristics due to the nature of the product. OPGI does not consider these minor imperfections as damaged. These items will be easily corrected during the filling, priming and sanding phase of your sheet metal installation. All sheet metal panels will require some sort of manipulation during installation. Every panel that we sell is inspected and then carefully packaged to protect against damage that may occur during transit. Test Fit All Panels Prior To Paint and Installation: OPGI recommends test-fitting all sheet metal panels prior to final paint and installation. It is also recommended that the damaged area of the vehicle not be cut out before receiving the new sheet metal. Measure twice, cut once to be safe. Sheet metal panels are not a finished product like door handles and mirrors. Minor modifications including elongating mounting holes, adding shims etc. are normal and may be necessary when installing sheet metal. This is a consideration when reinstalling original GM panels as well as reproductions. It is important to note that hard driving conditions can twist frames and bodies out of original tolerances. Poor bodywork from previous collisions can cause problems with the body structures that the panels are attached to.