Relay, Solid State, MSD, 4 Channel

New Solid State Relays!

Four relays in one convenient block

Clean up your wiring with an MSD Solid State Relay Block. This module takes the place of 4 standard relays and eliminates unsightly wiring. 4 independent channels can be activated using either power or ground. With 4 channels the relay block is available with 200 or 400 amps of momentary and 80 or 140 amps constant combined power, you can easily control electric fans, water pumps, nitrous solenoids, auxiliary lighting and any other electrical accessories that would normally require a relay. LED status indicators ensure proper wiring and operation of each channel. Should a problem arise, the relay block has built-in automatic over-temp, short circuit and overload protection. The block can easily be mounted using the supplied hardware and mounting tabs that can be rotated 90° to accommodate various mounting locations. Its compact and clean design will make your wiring project a breeze. Available in red or black.

FEATURES: Operates from 7-Volts to 20-Volt supply Channels can be run in parallel for devices requiring more than the single-channel rating Clean, easy install with minimum wiring Over-temp, short circuit and overload protection Diagnostic LED’s and status indicators Single wire activation by switching power or ground A PWM signal can be used in the Solid-State Relay Module with a maximum frequency of 150 hertz and a duty cycle range from 50% to 90%.