Display Controller, AutoMeter OBDII Dash, 2015-16 Escalade

Add Additional Engine Parameters To Your Dash

AutoMeter’s remarkable DashControl™ utilizes your vehicle’s factory dash display to provide performance information without modification. DashControl™ plugs into the OBDII port and “hijacks” these displays, allowing you to monitor parameters from the vehicle’s data bus. Customize the display pages to display what you want, where you want it. Because there is no modification to any of the vehicle’s computer systems, it’s 100% warranty friendly and reversible simply by unplugging the device. It’s the easiest, most integrated solution for gauges yet, and takes only seconds to install. DashControl™ offers customizable alerts as well. Water temp getting too hot or oil pressure dropping? DashControl™ can activate your factory warning chime and display an alert in the DIC at any value you set. Customization is incredibly easy using our intuitive configuration software. Better still, the system is expandable to add up to two additional analog inputs for parameters not monitored by your vehicle’s computer systems.

Supported PIDs: Engine Load (%), Engine Coolant Temperature (ºF, ºC), Short/Long Term Fuel Trip (%), Manifold Absolute Pressure (PSI, kPa), 0-60 MPH (Sec), Spark Timing (Deg.), Intake Air Temperature (ºF, ºC), Air Flow (g/s, lb/min), Throttle Position (%), Oxygen Sensor Voltage (mV), Fuel Level (%), 1/8, 1/4, or 1/2 Mile Time (Sec), plus many more